Lab Submission Details

<< Click to Display Table of Contents >>

Navigation:  LSPECS > Monitoring Rounds > Your Active > Lab Submissions >

Lab Submission Details

Previous pageReturn to chapter overviewNext page

Lab submissions for Scheduled or Planned Monitoring Rounds will be mostly pre-populated with details grouped in panels which can be clicked to view and edit the information in each.

For ad-hoc Monitoring Rounds, details will need to be populated from a blank template, or by copying an existing submission.  Each step is described below.

Once complete, submissions can be saved, printed or sent to the lab by clicking the appropriate button.

clip0559

 

Lab Submission Info

clip0556

The Project and Sites are derived from the Monitoring Round. These fields are read only and updated according to the Monitoring Round selection.

There is an option to auto generate the SDG/COC number. This is a concatenation of the following:

Abbreviation of destination lab; for example Australian Lab Services is abbreviated to ALS.
Numerical sequence of the SDG being submitted to the lab.

This can be updated to something specific to your organisation. It is important to note that the SDG/COC number must match the COC value sent with the samples to the laboratory.
 

Up to two labs can be defined for a Monitoring Round, the primary and secondary.  The samples will be sent to the lab shown here for Analyses.  Enter or select the following:

Lab Name - search for an existing lab or add a new lab for selection.
Lab Quote - select the lab quote from the lab. Note, it is optional to have a lab quote number defined.
Contact Name - search for an existing contact or add a new contact for selection.
Email - is a read only field populated from the selected contact.

 

Details about who in your organisation will receive laboratory communications are included in the Report To section.  Users a selected from the drop-down list.

 

Accounting information is entered in the PO and Bill To sections.

 

Turn-around times and special instructions can be entered to meet your Project requirements.

 

Submitted Samples

 

Sample information is entered into the form by expanding the fields using the >> button.

 

Type your values, or select from the drop-downs.

 

clip0553

 

 

Container information is added from the Lab Quote selected in the Lab Submission section, or from the internal quote.  Once added, enter the appropriate number of each container against the required sample.

 

clip0555

 

Analysis information is added from the Lab Quote selected in the Lab Submission section, or from the internal quote.  Once added, analysis is assigned to a sample by checking the box.

 

clip0554

 

 

Relinquishment of Physical Samples

The handover details must be completed before sending to the laboratory. A validation message pops up if these details have not been entered when Send to Lab is clicked.

 

clip0557

 

Requests and Versions

A new request or version of an existing lab submission can be generated and sent to the lab.

Details of Requests and Versions can be found here.