Stabilisation Recording

<< Click to Display Table of Contents >>

Navigation:  Field Portal > Monitoring Rounds > Location Visits >

Stabilisation Recording

Previous pageReturn to chapter overviewNext page

Sample Data can be configured to show one set of final readings for a sample. If Stabilisation Recording has been enabled for the Field Profile then purge results can be recorded for a sample.

 

The following two settings for Sample Data - Analytes in the field profile determine the type and sensitivity of the stabilisation:

 

Stabilisation Amt: 

The range consecutive readings must fall within to be considered stable.

Stabilisation Amt. Type: 

Percentage or an absolute value can be used for the stabilisation calculation. 

Stabilisation Readings:

The number of previous consecutive readings which must be taken into account when calculating stabilisation

 

clip0443

 

 

Stabilisation readings are recorded with a time stamp and can be scrolled through to review and update or delete. Comments can be added against each analyte reading.

The time between readings is calculated and the overall stability is indicated as green = stable and red = unstable based on the calculation parameters defined in the field profile.

 

 

clip0444